Zapi COMBI AC1 Specifikace stáhnout pdf (Strana 57)

2=CA#$

4. LOGIC FAILURE #2

Fault in the hardware section of the logic board which manages the phase' s voltage

feedback. Replace the logic board.

5. LOGIC FAILURE #3

Fault in the hardware section of the logic board which manages the hardware current

protection. Replace the logic board.

6. CHECK UP NEEDED

This is a warning. It is an information for the user that the programmed time for main-

tenance is elapsed.

7. INCORRECT START

This alarm signals an incorrect starting sequence. Possible causes:

a. running microswitch failure;

b. error in sequence made by the operator;

c. incorrect wiring;

d. if the default persists, replace the logic.

8. FORW + BACK

The test is carried out continuously. An alarm is signalled when a double running

request is made simultaneously. Possible causes:

a. defective wiring;

b. running microswitch failure;

c. incorrect operation;

d. if the defect persists, replace the logic.

9. HANDBRAKE

The truck does not start because the handbrake switch is opened. Possible causes:

a. defective wiring;

b. failure of the microswitch;

c. incorrect operation of the operator;

If the defect persist , replace the logic.

10. CAPACITOR CHARGE

Follows the charging capacitor system:

When the key is switched ON, the inverter tries to charge the capacitor through a

power resistance, and check if the capacitor are charged within a timeout. If this is

not true: an alarm is signalled; the main contactor is not closed.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62

Žádné komentáře

Zapi COMBI AC1 Specifikace Strana 57